- #PETERBILT AUTOMATIC TRANSMISSION DRIVER#
- #PETERBILT AUTOMATIC TRANSMISSION MANUAL#
- #PETERBILT AUTOMATIC TRANSMISSION SOFTWARE#
- #PETERBILT AUTOMATIC TRANSMISSION CODE#
Note: If the codes have been successfully cleared, the service lamp will come on and stay on for five seconds.Ģ. Turn the key OFF and ON six times within five seconds, ending with the key in the ON position. A one or two second pause separates each stored code, and the sequence automatically repeats after all codes have been flashed.ġ. Two digit fault codes will be displayed in the gear display.
#PETERBILT AUTOMATIC TRANSMISSION CODE#
If no codes are active, the gear display will flash code 25 (no codes).Ħ. After five seconds, the gear display begins flashing two-digit fault codes.
#PETERBILT AUTOMATIC TRANSMISSION MANUAL#
Turn the key OFF and ON four times within five seconds ending with the key in the ON position. TRANSMISSIONS LOW D N R Reverse Neutral Drive Manual Low - Upshift - Downshift Button not used Service Indicator Fleet Breakdown Quick Reference Guide Eaton UltraShift PLUS and Fuller Advantage Automated Transmissions TRDR0943 EN-US April 2016 Important: This is a quick reference guide only. To Retrieve Inactive Codes: Start with the key in the ON position. To start engine turn key off and wait for the transmission to power down.ĥ. You must turn vehicle key OFF and allow the system to power down to exit PD mode before restarting. If there are inactive codes PD (Product Diagnostic mode) will be displayed. If there are no active codes the gear display will show code 25.
Turn the key OFF and ON two times within five seconds ending with the key in the ON position. To Retrieve Active Codes: Start with the key in the ON position. If the engine is already running, you may still retrieve codes, however, do not engage the starter if engine stalls.Ĥ.
Turn the ignition key ON but do not start the engine. I have not tried it, but it sure can't hurt anything.ģ. The Model 389 is available with the powerful, fuel-efficient PACCAR MX-13 engine with power ratings up to 510 hp and 1,850 lb.-ft. It might reset the auto trans and allow you to get rolling again. I just don't want to be paying the dealer $125 per hour to try and fix the don't know if this will work, but found it on a Google Search. Unfortunately, none of the independent shps know these transmissions well and even the International dealer said they rarely work on them. Anyone know these transmissions well and can point me in the right direction. Browse a wide selection of new and used PETERBILT 567 Trucks for sale near you at. Problem is the yesterday the service light went on before this happened.
#PETERBILT AUTOMATIC TRANSMISSION DRIVER#
No I'm thinking that maybe the driver did this and that's why it didn't start back up.
#PETERBILT AUTOMATIC TRANSMISSION SOFTWARE#
I purchased a copy of Road Ranger software on ebay to pull codes out of transmission and the only code it had in it was something about truck was shut down without putting in neutral which could cause a no start situation. If your Peterbilt has an automatic transmission, there are a few things you need to do in order to reset it. 10-3/8 frame rail Front Axle - Eaton Fuller 12,000. When we got back to the truck, the driver jumped in the truck and it started back up without disconnecting the batteries. Make: Peterbilt Year: 1990 Model: 379 Engine: Cat C3406 425HP Transmission: Fuller RTO14609B Recent repairs listed in the photos. We drove back to the shop to get a wrench to disconnect the batteries. We quickly figured out the reason the truck wasn't starting was it was in gear and the neutral light wasn't on in the console. Today the driver shut the truck off and when tried to restart the truck, it wouldn't start. The other day the driver said the service light came on on the console shifter after a short trip. We've got a 2010 International 8600 with an Eaton Ultrashift 10 speed.
0 kommentar(er)
